Description
This is a single AR70/90 Receiver flat. Note, this is a true flat, and no form has been applied. There are two tight back-to-back bends that need to be made, plus 6 more straight bends to make and several holes to drill for spot welds. Each Flat has small bend line markers on each front and rear edge to make aligning your part in the brake easier. The tic marks indicate the centerline of each bend.
That said, this flat has all the weld locations for the front trunnion and rear takedown block cut out, as well as the rivet holes for the internal rails. If you prefer to bend your flat first and THEN punch/cut the holes for your welds and rivets, you should order flat AR70/90RF-N, which has no holes pre-cut.
Reviews
There are no reviews yet.